Hi Bruce, I don't find "athena preferences menu" when I open athena... I can only see "service preferences" under perl5.22, which is the preferences for my mac not for athena...
I just found if I set terminal to qt, it showed "unknown". If I set to x11, it showed "nopersist enhanced". If I set to wxt, it showed "0 enhanced". Are these normal? Thanks, Chloe On Wed, Oct 7, 2015 at 12:26 PM, Chloe Yi-Yi Wu < [email protected]> wrote: > Hi Bruce, > > I just upgraded my mac from mountain lion to el capitan. I was using the > old version, iXAFS, but I can't launch it on the new el capitan. I then > installed Demeter with Macport by following the instructions. However, I'm > not able to plot the data in athena and artemis. > > I read the thread about "no plot window on Yosemite", but still have no > clue. I can plot gnuplot in aqua, x11 and wxt. It seems whenever I quit > gnuplot to launch athena and enter gnuplot later again, it will always go > back my default terminal, aqua, no matter how I set terminal. Is there a > communication problem between Demeter and aqua? I'm not familiar with these > commands, to be honest. If I did something wrong, please advise. > > Thanks, > Chloe > > -- > Yi-Yi (Chloe) Wu > Kung Research Group > Dept. of Chemical and Biological Engineering > Northwestern University > Evanston, IL USA > -- Yi-Yi (Chloe) Wu Kung Research Group Dept. of Chemical and Biological Engineering Northwestern University Evanston, IL USA
_______________________________________________ Ifeffit mailing list [email protected] http://millenia.cars.aps.anl.gov/mailman/listinfo/ifeffit
