[linrad] Sound card sample delay

[Alberto E. Zagni]

Hi all,
I am new to the world of Linrad, so my request can be obvious for 
many...sorry.
I am using a notebook with Audigy2 ZS PCMCIA audio card running at 96000 
sample 16 bit and an SDR-X I/Q receiver.
With other software (Winrad, Rocky) I must enable 1 sample delay on the 
right channel to get proper image cancellation.
If I don't delay the right channel it's impossible to get more than 15 / 20 
dB of cancellation, while with delay ON I can get easily 70 dB on any 
specific frequency and about 50 dB on the 90k band.
I know this problem is typical of most low cost audio card and laptop 
internal card, while is absent on the Delta 44.
I see no way of enabling this delay in Linrad (I am using it currently under 
Windows). Any help / advice?

Best regards
Alberto I2KBD


#############################################################
This message is sent to you because you are subscribed to
 the mailing list <linrad@antennspecialisten.se>.
To unsubscribe, E-mail to: <[EMAIL PROTECTED]>
To switch to the DIGEST mode, E-mail to <[EMAIL PROTECTED]>
To switch to the INDEX mode, E-mail to <[EMAIL PROTECTED]>
Send administrative queries to  <[EMAIL PROTECTED]>