On Sun, Mar 16, 2008 at 1:22 AM, Antti Palosaari <[EMAIL PROTECTED]> wrote:
> > Jarryd Beck wrote: > > > Michael's patch didn't produce any interesting dmesg output. I included > > > dmesg for plugging in and tuning with antti's patch. > > First errors came from same situation as earlier, no_reconnect. But it > finally still worked. > > > > Just realised I didn't have debug enabled for Michael's patch. When > > tuning I got lots of this: > > > > tda18271_set_standby_mode: sm = 0, sm_lt = 0, sm_xt = 0 > > tda18271_init_regs: initializing registers for device @ 1-00c0 > > tda18271_tune: freq = 219500000, ifc = 3800000, bw = 7000000, std = 0x1d > > > > My keyboard was fine this time (that was the point it normally responded > > really slowly), and the driver loaded instantly instead of taking nearly > > half a minute. > > It looks like it might be a step in the right direction, but it's still > > not tuning. > > > > Jarryd. > > Frequency control values of the demodulator seems to be ok now. Also adc > and coeff looks correct. It is hard to say where is problem... > Can you test if demodulator can detect TPS parameter automatically? You > can do that inserting AUTO to initial tuning file, for example set FEC > AUTO. And then "scan tuning-file" > > > > > regards > Antti > -- > http://palosaari.fi/ > Sorry I'm completely lost at this point, are you talking about adding something to /usr/share/dvb-apps/dvb-t/au-sydney_north_shore and then running scandvb, or are you talking about something else? Jarryd. _______________________________________________ linux-dvb mailing list linux-dvb@linuxtv.org http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
