what is the output of `dmesg` when you connect the device to the machine ? e.g, should be something like this,
[393503.604738] usb 1-4.2: new full-speed USB device number 71 using xhci_hcd [393503.698674] usb 1-4.2: New USB device found, idVendor=1a86, idProduct=7523 [393503.698678] usb 1-4.2: New USB device strings: Mfr=0, Product=2, SerialNumber=0 [393503.698681] usb 1-4.2: Product: USB2.0-Serial [393503.757764] usbcore: registered new interface driver ch341 [393503.757789] usbserial: USB Serial support registered for ch341-uart [393503.757808] ch341 1-4.2:1.0: ch341-uart converter detected [393503.758600] usb 1-4.2: ch341-uart converter now attached to ttyUSB0 -- Rabin On 20 June 2017 at 14:20, Shlomo Solomon <shlomo.solo...@gmail.com> wrote: > Sorry - just noticed I cut off part of the error message, so here it is > again: > > WARNING: RXTX Version mismatch > Jar version = RXTX-2.2 > native lib Version = RXTX-2.2pre2 > Binary sketch size: 1,056 bytes (of a 32,256 byte maximum) > avrdude: stk500_recv(): programmer is not responding > avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00 > avrdude: stk500_recv(): programmer is not responding > avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x00 > > > > > > On Tue, 20 Jun 2017 13:32:28 +0300 > Shlomo Solomon <shl...@the-solomons.net> wrote: > > > I installed the Arduino IDE from Mageia RPMs and added my user to the > > lock group as instructed. > > > > In the tools >> serial port menu, there is no /dev/ttyUSB0 - > > only /dev/ttyS0 and /dev/ttyS1. I tried both of them but could not > > upload a program. I read that sometimes Arduino needs to be run as > > root, so I tried that too with no success. Here's what I get when I > > try to upload: > > > > Binary sketch size: 1,056 bytes (of a 32,256 byte maximum) > > Binary sketch size: 1,056 bytes (of a 32,256 byte maximum) > > avrdude: stk500_recv(): programmer is not responding > > avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00 > > avrdude: stk500_recv(): programmer is not responding > > avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x00 > > avrdude: stk500_recv(): programmer is not responding > > > > > > > > > > -- > Shlomo Solomon > http://the-solomons.net > Sent by Claws Mail 3.11.1 - KDE 4.14.5 - LINUX Mageia 5 > > > _______________________________________________ > Linux-il mailing list > Linux-il@cs.huji.ac.il > http://mailman.cs.huji.ac.il/mailman/listinfo/linux-il >
_______________________________________________ Linux-il mailing list Linux-il@cs.huji.ac.il http://mailman.cs.huji.ac.il/mailman/listinfo/linux-il