Re: Configuring Lyx

[Tom Beale]

It doesn't configure with both xforms and xforms-devel either 0.88 or 0.89.
I have tried make distclean, which didn't solve it, and neither did deleting
it all and re-expanding it from the .tar archive.

Tom.
----- Original Message -----
From: Paul E Johnson <[EMAIL PROTECTED]>
To: Tom Beale <[EMAIL PROTECTED]>
Sent: Thursday, October 12, 2000 1:24 PM
Subject: Re: Configuring Lyx


> Your devel edition must match your xforms edition.  Where are you
> getting the rpm for 0.89?
>
> OK, so I'm just guessing.
>
> One of the most common problems is that people have configure fail, and
> then they install what they need, and run configure again in the same
> place. It uses the cached settings from the last configure. I think lyx
> has "make distclean" to get a fresh start. If not, you have to erase the
> source tree and try again.
>
>
> pj
>
> Tom Beale wrote:
> >
> > I already had xforms-devel 0.88 installed.   I have now tried installing
> > xforms-devel 0.89-6 but that doesn't seem to make any difference.
> >
> > Tom.
> > ----- Original Message -----
>
>
> --
> Paul E. Johnson                       email: [EMAIL PROTECTED]
> Dept. of Political Science            http://lark.cc.ukans.edu/~pauljohn
> University of Kansas                  Office: (785) 864-9086
> Lawrence, Kansas 66045                FAX: (785) 864-5700
>