Hi, On Wed, May 18, 2011 at 1:37 PM, <h.pa...@accenture.com> wrote: > My audio.conf looks as below. > > Configuration file for the audio service > > # This section contains options which are not specific to any > # particular interface > [General] > Enable=Source > # Switch to master role for incoming connections (defaults to true) > #Master=true > > # If we want to disable support for specific services > # Defaults to supporting all implemented services > #Disable=Control,Source > > # SCO routing. Either PCM or HCI (in which case audio is routed to/from ALSA) > # Defaults to HCI > #SCORouting=PCM > > # Automatically connect both A2DP and HFP/HSP profiles for incoming > # connections. Some headsets that support both profiles will only connect the > # other one automatically so the default setting of true is usually a good > # idea. > #AutoConnect=true > > # Headset interface specific options (i.e. options which affect how the audio > # service interacts with remote headset devices) > [Headset] > > # Set to true to support HFP, false means only HSP is supported > # Defaults to true > HFP=true > > # Maximum number of connected HSP/HFP devices per adapter. Defaults to 1 > MaxConnected=1 > > # Just an example of potential config options for the other interfaces > #[A2DP] > #SBCSources=1 > #MPEG12Sources=0 >
So this means you are using the old unix socket API, which is fine and should work normally too. Could you please run hcidump -XVt and send us the output? -- Luiz Augusto von Dentz Computer Engineer _______________________________________________ pulseaudio-discuss mailing list pulseaudio-discuss@mail.0pointer.de https://tango.0pointer.de/mailman/listinfo/pulseaudio-discuss
