Re: Hex Bronze?

[Harry Wade]

At 11:21 AM 2/14/05 -0600, you wrote:
>Rolling in on the heels of the brass vs. bronze question....
>Does anyone have a readily available source for HEX bronze? - Mike Eorgoff

Mike,
   That's going to be a real toughie, especially if you want smaller than
1/2" hex in a small quantity.  I couldn't find a ready source on the www
but Chronos (in the UK) has some around .250" and .325".  Depending upon
the quantity you need it may be cheaper and quicker to mill it from a round
bar.

Regards,
Harry