I think I made some progress. I uncommented the lines which did differ from the pypy original contribution of Seufer. It was not compiling, with an error telling "error: $fp cannot be used in asm here" I found that removing a register ($30) from REGS_TO_SAVE was removing the error. I do not understand what I did. But now the lines are uncommented and it compiles.
With these informations in mind, I made another attempt. I see alot of warnings and errors, but something gets produced and installed in my target directory. I have yet to test it in the router. I will be able to do this this afternoon. Anyway, I would appreciate any sort of hints that you may think about. I attach (following mails) the output of configure/make/make install Please note that the line telling #warning 'orig slp_switch mips non-64' indicates that the file Stackless/platf/switch_mips_unix.h is processed while the file Stackless/platf/slp_switch_stack.h is not and that my arch is not 64 bit. Thanks and regards --Luca _______________________________________________ Stackless mailing list [email protected] http://www.stackless.com/mailman/listinfo/stackless
