Hello. Will NC393 boards will be backward compatible with 323 hardware? Best regards, Yakov Petrov.
On Sat, Aug 22, 2015 at 1:25 AM, Yakov <queila...@gmail.com> wrote: > Hello Andrey. I will still need two 10353 boards for each camera? It means > I will need 6 boards for all the project. > > Regards, > Yakov. > > On Fri, Aug 21, 2015 at 11:56 PM, support-list < > support-list@support.elphel.com> wrote: > >> Hello Yakov, >> >> Running KAI11002 at higher pixel rate decreases the dynamic range, and >> the Model 323 was designed to provide full dynamic range that sensor can >> provide while the required frame rate for book scanning was just 1 frame >> per 1.5 second. All the timing of the CCD is implemented in the FPGA so it >> is possible to increase the frame rate (you will also need to replace 10313 >> boards with 10353 as the older AXIS CPU had limited network bandwidth due >> to software checksum calculation). On the other hand, reducing the dynamic >> range by increasing the frame rate would reduce advantage of that CCD image >> sensor and you will get performance of the newer CMOS image sensors that >> are much easier to operate. >> >> Andrey >> >> ---- On Fri, 21 Aug 2015 09:03:48 -0700 *Yakov <queila...@gmail.com >> <queila...@gmail.com>>* wrote ---- >> >> Hello. I have one question. It's mentioned in that model 323 can only >> shoot 2 fps. But it's matrix can do 4.8 fps at 30mhz. Can model 323 can be >> somehow upgraded to do 4.8 fps? >> >> Best regards, >> Yakov Petrov. >> _______________________________________________ >> Support-list mailing list >> Support-list@support.elphel.com >> http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com >> >> >> >> >
_______________________________________________ Support-list mailing list Support-list@support.elphel.com http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
