[uClinux-dev] [RFC 11/11] m68knommu: dont touch the irq controler in the pit driver

[Sebastian Siewior]

The M523x initialized the irq controller properly, the driver must not do
it anymore.
Signed-off-by: Sebastian Siewior <[EMAIL PROTECTED]> 
--- a/arch/m68knommu/platform/coldfire/pit.c
+++ b/arch/m68knommu/platform/coldfire/pit.c
@@ -178,11 +178,13 @@ void hw_timer_init(void)
 
        setup_irq(MCFINT_VECBASE + MCFINT_PIT1, &pit_irq);
 
+#if !defined(CONFIG_M523x)
        __raw_writeb(ICR_INTRCONF, INTC0 + MCFINTC_ICR0 + MCFINT_PIT1);
        imr = __raw_readl(INTC0 + MCFPIT_IMR);
        imr &= ~MCFPIT_IMR_IBIT;
        __raw_writel(imr, INTC0 + MCFPIT_IMR);
 
+#endif
        pit_clk.mult = clocksource_hz2mult(FREQ, pit_clk.shift);
        clocksource_register(&pit_clk);
 }

-- 

_______________________________________________
uClinux-dev mailing list
uClinux-dev@uclinux.org
http://mailman.uclinux.org/mailman/listinfo/uclinux-dev
This message was resent by uclinux-dev@uclinux.org
To unsubscribe see:
http://mailman.uclinux.org/mailman/options/uclinux-dev