on 6/29/04 2:37 PM, Ken at [EMAIL PROTECTED] wrote: > Acquired a 7100/80 a couple of days ago with hopes of > replacing a 7100/66 as a Sonnet G3 upgraded NuBus Mac. > > Swapped the logic boards as the /80's case was in rough > shape. Reassembled and booted to test the assemble. With > the case top off, it booted fine and seemed "happy." > > Slid the top back on and hit the power key; Got the boot > chime and then it stopped at the grey screen with a cursor > arrow. PRAM reset 5 times; nothing but the grey screen. > > Started parts swapping to isolate the problem. No luck. > > Tested all parts except the logic board in the original > 7100/66. Boots and runs great. > > Did I get the final few minutes of life out the old thing > when I first tested it with the top off? > > Any suggestions welcome! > > Ken ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Doesn't sound like it. I would remove the hard drive's cable, and the CD ROM's cable and boot it to a question mark, if it'll go. Then look into your SCSI cable or the device's setting. Next try the hard disk's jumpers and cable condition. ALso, look to see if the RAM is firmly planted, and if any can be bad. Jeff G. -- 1st-PowerMacs is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | -- Sonnet & PowerLogix Upgrades - start at $169 | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> 1st PowerMacs list info: <http://lowendmac.com/lists/1st-powermacs.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> List archive: <http://mail.maclaunch.com/lists/1st-powermacs/> --------------------------------------------------------------- >The Think Different Store http://www.ThinkDifferentStore.com ---------------------------------------------------------------
