for plan 9, for the older 4501 i think i had to eliminate some cga references
in config and mkfile. use a mkfile without cga.$O (this
would be better done by specifying cga in the other config files, since it's
optional).
i used an earlier verson of the pcsoe config file below, but
had to add the dummy realmode this time to get it to compile.
that won't work unless there's a
plan9.ini as well with *norealmode=1
i can't remember what i did for plan9.ini.
for inferno i just needed a configuration file
because i'd once had to port it to a 386dx/16 without
cga, so i'd already made appropriate changes.
dev
root
cons
arch
pnp pci
env
pipe
proc
mnt
srv
dup
rtc
ssl
tls
bridge log
sdp thwack unthwack
cap
kprof
ether netif
ip arp chandial ip ipv6 ipaux iproute netlog nullmedium
pktmedium ptclbsum386 inferno
sd
uart
pccard
i82365 cis
link
devpccard
devi82365
ether83815 pci
etherwavelan wavelan devi82365 cis
ethermedium
loopbackmedium
netdevmedium
misc
uarti8250
sdata pci sdscsi
ip
il
tcp
udp
ipifc
icmp
icmp6
gre
ipmux
esp
rudp
port
int cpuserver = 1;
void screeninit(void){}
void realmode(Ureg*){}
boot cpu
il
tcp
bootdir
bootpcsoe.out boot
/386/bin/ip/ipconfig ipconfig
/386/bin/auth/factotum--- Begin Message ---
> - get plan9/inferno run on soekris net5501 board
i thought plan 9 ran just fine on those.
- erik
--- End Message ---
