On May 6, 2011, at 1:36 AM, Anthony Sorace wrote: > I have a VM that I created under Parallels 5 and am currently running under > 6. It's several months old.
I seem to have gotten my version numbers mixed up. It's Parallels 6 over here as well. >> 1. ps2intellimouse: scrolling works if you're scrolling down, but if you >> make the scroll up gesture, the mouse skitters off to the right and really >> doesn't scroll back up. Anyone seen this or have a tricky solution? > > I saw this for the first time today. In my case, scrolling up *also* creates > occasional b2 presses. Weird. I haven't used the GUI on Parallels much for > two years, so I can't help with when it was introduced. > >> 2. Ethernet card is not detected. I am not 100% sure there's nothing >> different in the configuration, but I've made the plan9.ini look the same in >> both VMs and still it fails to detect the NE2000 emulated ethernet card. >> There are also ominous messages about usbd: no hub during bootup that don't >> happen under the old one. > > Ethernet works here (and did under Parallels 5, as well), and I've got > nothing in plan9.ini to trick it. You don't see the device at all (not just > no data or whatnot)? There's no /net/ether0, so I can't run ip/ipconfig to get any further. >> Is there a boot log somewhere I can examine for messages I may not have >> seen, or any other debugging information I can go looking for? > > /dev/kmesg will give you the console prints so far; /dev/kprint will wait for > new ones (and prevent them going to your actual console). I don't see anything interesting there, except that it couldn't initialize usbd. Does usbd work for you? — Daniel Lyons
