sorry.. very new to plan9 how to I open a new terminal to run the command?
On Sat, Feb 16, 2013 at 12:49 AM, erik quanstrom <[email protected]>wrote: > On Sat Feb 16 01:41:26 EST 2013, [email protected] wrote: > > > I'm trying to install Plan9 on my Thinkpad T410. I could boot using the > > latest Plan9.iso image and the install process gets to the diskpart step > > (the step after the configfs step) and it complains about not seeing any > > hard disks. > > > > I have Linux installed in one of the partitions and it shows the > following > > sata controller > > > > 00:1f.2 SATA controller [0106]: Intel Corporation 5 Series/3400 Series > > Chipset 6 port SATA AHCI Controller [8086:3b2f] (rev 06) > > > > I'm new to Plan 9. Any suggestions on how to debug this issue? > > > > I see two modes for SATA - AHCI and Compatibility. The above behavior is > > when SATA is in the AHCI mode. In the Compatibility mode, the install > fails > > earlier - boots from CD, but can't access it after that. > > could you send the output of > grep . /dev/sd*/ctl > > thanks! > > - erik > >
