On Thu, Jun 25, 2015 at 2:57 PM, Nils M Holm <n...@t3x.org> wrote: > > On 2015-06-25T13:09:00-0500, Ryan Gonzalez wrote: > > FYI, for what it's worth, I usually use SSH to sync files between > > my Linux laptop and my Plan 9 VM. > > Thanks for the suggestion! Care to give me a short introduction to > ssh on Plan 9? I normally avoid ssh like the plague, so I assume I > know nothing about it. > > I don't use FreeBSD, so this might be slightly wrong. :)
Sources: https://www.freebsd.org/doc/handbook/openssh.html http://plan9.bell-labs.com/wiki/plan9/connecting_to_other_OSes/index.html You want to do this in FreeBSD: - Edit /etc/rc.conf and check if this line is present: sshd_enable="YES" If it isn't, add it. - Edit /etc/ssh/sshd_config and add the following lines: Protocol 2,1 HostKey /etc/ssh/ssh_host_key AllowUsers username@plan9_machine_ip_address - Run: ssh-keygen -t rsa1 -f /etc/ssh/ssh_host_key chmod 644 /etc/ssh/ssh_host_key That's the setup. Now, whenever you want to access your machine's files from Plan 9, run this on FreeBSD: service sshd start And on Plan 9: ssh username@bsd_machine_ip_address Type 'yes' at any prompts that pop up. > > Also, last time I tried, VirtualBox was a bit faster in emulating > > Plan 9 than QEMU, especially without KVM. > > VirtualBox is much faster on my machine, but I don't manage to > set up any network connections at all. NIC is recognized, but > ip/ipconfig hangs and after configuring manually, not even ip/ping > works. So I'll stick to QEMU for now. > > -- > Nils M Holm < n m h @ t 3 x . o r g > www.t3x.org > -- Ryan [ERROR]: Your autotools build scripts are 200 lines longer than your program. Something’s wrong. http://kirbyfan64.github.io/
