> On Dec 17, 2019, at 1:31 PM, Richard Miller <9f...@hamnavoe.com> wrote:
>
>> I have a 2K display that Plan9 forces to 1920x1080 resolution.
>> Poking around 9/bcm/screen.c indicates that setting vgasize=WxHxD
>> should force the size, but adding a suitable entry in cmdline.txt
>> just gives me a blank display.
>>
>> Before I dig deeper, is this expected to work?
>
> Possibly not. I haven't tried vgasize= for years and there have been a
> lot of changes to the firmware & videocore mailbox interface since then.
>
> Plan 9 should accept whatever resolution comes from the gpu, so it
> may be the firmware which "forces" 1920x1080. Maybe gpu_mem needs
> to be bigger than the usual 16, or some other config.txt adjustment
> is needed?
I was able run earlier pis with a 4K@30Hz display but haven't tried this
with pi4. I had to use some custom parameters.
https://www.raspberrypi.org/documentation/configuration/hdmi-config.md
says to use hdmi_enable_4kp60=1 in config.txt if you have a 4k@60hz display.
You can choose custom modes as well. There is a config_hdmi_boost parameter
to increase HDMI drive strength but this doesn't work for pi4.
------------------------------------------
9fans: 9fans
Permalink:
https://9fans.topicbox.com/groups/9fans/T83b43600a3d592d7-Md2bdaab4daa0c8cdfef4f1ec
Delivery options: https://9fans.topicbox.com/groups/9fans/subscription
