I'm not sure about the "Table:" beginning of the line (maybe there is no prefix at all), but definitely the rest is /mnt/tables/gsm/100.ins 100 0
On 11.4.2016 21:02, [email protected] wrote: > Thanks Jan. > > Furthermore, could you tell me which of the following given below is the > correct format for tables.conf? > > #Settings A: > #============================ > Tables: /mnt/tables/gsm/100.ins 100 0 > Tables: /mnt/tables/gsm/108.ins 108 0 > . > . > Tables: /mnt/disk2/gsm/500.ins 500 0 > #============================ > > > OR > > #Settings B: > #============================ > Tables: /mnt/tables/gsm/100.ins 100 1 > Tables: /mnt/tables/gsm/108.ins 108 1 > . > . > Tables: /mnt/disk2/gsm/500.ins 500 1 > #============================ > > OR > > #Settings C: > #============================ > Table: 0 100 0 > Table: 1 108 0 > Table: 2 116 0 > . > . > Table: 39 500 0 > #============================ > > Which one of the above has the correct syntax? A,B,C OR none ! > Note that some of the tables are on a separate disk :( > > Regards, > Spørgeren > > > On 2016-04-09 18:31, Jan Hrach wrote: >> The offset is meant to be used when you are converting multiple tables >> to raw device without filesystem. >> You definitely want all tables to start at offset 0 when you have them in >> files. >> >> Offset :1 would mean 4096 from the beginning, which makes no sense. If >> you were to put it to the device, you will have to see how many blocks >> were written and then set the offset to that (maybe +1). These offsets >> are expected to be around 10000000. >> >> On 9.4.2016 12:50, [email protected] wrote: >>> Dear all, >>> >>> While manually converting dlt files to idx and inx using: >>> >>> ./TableConvert di /media/tables/a51_table_100.dlt /media/GSM/100.ins:0 >>> /media/GSM/100.idx >>> >>> Do I keep the offset the same for all remaining files as well? >>> >>> Example: >>> >>> ./TableConvert di /media/tables/a51_table_268.dlt /media/GSM/268.ins:0 >>> /media/GSM/268.idx >>> >>> OR >>> >>> Does the offset (ins:0) change or increment in a pattern to ins:1 ins:2 .. >>> etc. ? >>> >>> Regards, >>> Spørgeren >>> _______________________________________________ >>> A51 mailing list >>> [email protected] >>> https://lists.srlabs.de/cgi-bin/mailman/listinfo/a51 > > _______________________________________________ > A51 mailing list > [email protected] > https://lists.srlabs.de/cgi-bin/mailman/listinfo/a51 -- Jan Hrach | http://jenda.hrach.eu/ GPG CD98 5440 4372 0C6D 164D A24D F019 2F8E 6527 282E _______________________________________________ A51 mailing list [email protected] https://lists.srlabs.de/cgi-bin/mailman/listinfo/a51
