Thanks. I did connect finally with 2 other endpoints in Seattle and Washington by going unicast, though my video was choppy. I will switch out the camera and see if it makes a difference.
However, after about 10 minutes, I received another "vic.exe" error and it shut down. I re-started and ran for a short period of time, then it froze and I received a "python.exe" error. Any thoughts? Thanks, Nora www.druidmedia.com ----- Original Message ----- From: "Michael Braitmaier" <braitma...@hlrs.de> To: "Thomas D. Uram" <tu...@mcs.anl.gov>; "Nora Barry" <noraba...@druidmedia.com> Cc: <ag-t...@mcs.anl.gov> Sent: Wednesday, February 23, 2005 4:20 AM Subject: Re: [AG-TECH] Vic.exe error > I had a similar problem with a Logitech webcam on my Windows XP workstation. > I couldn't resolve it, as it seemed to be a driver problem. Maybe a driver > update could have fixed the problem, but I didn't look out for a new driver > update, but switched over to another webcam. > > FYI, I think I used a Logitech QuickCam Messenger. > > Michael > > > ----- Original Message ----- > From: "Thomas D. Uram" <tu...@mcs.anl.gov> > To: "Nora Barry" <noraba...@druidmedia.com> > Cc: <ag-t...@mcs.anl.gov> > Sent: Tuesday, February 22, 2005 7:31 PM > Subject: Re: [AG-TECH] Vic.exe error > > > I think you mean that you can receive, but not transmit. > > I've seen this problem when the selected capture source is no longer > present, which can be > the case if the camera has been unplugged, or the card has been removed from > the machine. > In either case, you can't get data through the selected driver. > > Make sure the camera works in other applications, note the driver, and try > to use the same > one in vic. If you have problems here, update/reinstall the camera driver. > > Do you have multiple options for capture source in the 'configure on > transmit' window? > > Tom > > > Nora Barry wrote: > > Hi, > > > > > > I have not been able to receive video, tho I can transmit it. I followed > > the tutorial for video troubleshooting. The steps I took were these: > > > > > > à Encoder > > > > à Options > > > > à Configure on transmit > > > > à Video format > > > > à Camera controls > > > > à Capture source > > > > > > When I hit apply in capture source, I received a “vic.exe” error and it > > shut down. This has happened 4 or 5 times. I de-installed and then > > re-installed everything...and the same thing happened. Any ideas? > > > > > > > > Thanks, > > > > > > Nora Barry > > > > www.druidmedia.com/index_sub.html > > <http://www.druidmedia.com/index_sub.html> > > > > > > > >
