Hello, Unplug your braille Display cable from the computer and wait for 2 minutes. Now plug the cable again, wait for some time, you should hear a ding sound confirming a hardware detection. If you don't get that ding sound, it would be good to check your cable else problem might be with the Display drivers, in this case you should un-install and re-install JAWS. Contact me off list if you like. Thanks Mukesh
-----Original Message----- From: accessindia-boun...@accessindia.org.in [mailto:accessindia-boun...@accessindia.org.in] On Behalf Of Adina Galani Sent: Tuesday, September 22, 2009 10:14 PM To: accessindia@accessindia.org.in Subject: [AI] Braille display HI there, Am having a braille display, an old model, combibraille 85. Till yesterday it worked well with jaws 10, now, I do not know what happened, but it can't be detected. No ideea how to configure it so long it doesn't appear in the default lists. A little guidance needed please, in configuring this again. Regards, Adina To unsubscribe send a message to accessindia-requ...@accessindia.org.in with the subject unsubscribe. To change your subscription to digest mode or make any other changes, please visit the list home page at http://accessindia.org.in/mailman/listinfo/accessindia_accessindia.org.in To unsubscribe send a message to accessindia-requ...@accessindia.org.in with the subject unsubscribe. To change your subscription to digest mode or make any other changes, please visit the list home page at http://accessindia.org.in/mailman/listinfo/accessindia_accessindia.org.in
