Hi Andy,
when I backup this drive (t$) by scheduler the filespacename is
created using the clustername (derived from the /clustername:xxxx option
in the service definition) as \\xxx\t$.
As I cannot specify the clustername when I use the GUI I therefore cannot
backup cluster drives using the GUI.
Is this understanding correct? Or how would you suggest backing up cluster
drives via the GUI?
Kind regards
Thomas Rupp
Vorarlberger Illwerke AG
MAIL: [EMAIL PROTECTED]
TEL: ++43/5574/4991-251
FAX: ++43/5574/4991-820-8251
> -----Urspr�ngliche Nachricht-----
> Von: Andy Raibeck [SMTP:[EMAIL PROTECTED]]
> Gesendet am: Dienstag, 12. September 2000 00:18
> An: [EMAIL PROTECTED]
> Betreff: Re: TSM 3.7.2 client on MS cluster
>
> Regarding the first issue (filespace \\node2\t$ being
> created): this is correct. The filespace name is based
> on the UNC name of the drive, which in turn is based on
> the machine name. So if the machine name is NODE2, then
> \\node2\t$ is the correct filespace name.
>
> On the second issue: As Arturo mentioned, we are
> investigating this.
>
> Regards,
>
> Andy
>
> Andy Raibeck
> IBM/Tivoli
> Tivoli Storage Manager Client Development
> e-mail: [EMAIL PROTECTED]
> "The only dumb question is the one that goes unasked."
>
> I have this same problem, I have opened up a problem with TIVOLI. I can
> restore from the command line without problems, but from the GUI I can
> only
> restore from the file level. I cannot restore from the root level or
> folder
> level.....
>
> Good luck They are suppose to be working the problem.
>
> Arturo
>
> -----Original Message-----
> From: Rupp Thomas (Illwerke) [SMTP:[EMAIL PROTECTED]]
> Sent: Sunday, August 27, 2000 10:44 AM
> To: [EMAIL PROTECTED]
> Subject: TSM 3.7.2 client on MS cluster
>
> Hi TSM-gurus,
>
> I'm running TSM client 3.7.2 on a MS Windows NT 4.0 cluster.
> When I start the GUI with "DSM -optfile=T:\adsm\dsm.opt"
> (the same optfile is used by the scheduler) I get the following
> two
> problems:
>
> - On backup TSM creates a filespace using the wrong name. As the
> nodename is "DATEN" and the name of the machine is "NODE2" TSM
> should create a filespace named "\\DATEN\T$" but the GUI creates
> "\\NODE2\T$".
> - On restore I can only select single files, no directories. When
> I
> remove
> "CLUSTERNODE YES"
> from DSM.OPT this problem vanishes.
>
> I think I'll have to specify the /clustername when I start the GUI
> -
> but I
> don't know how!
> How do you start the GUI on a MS cluster and/or have you seen this
> behavior?
>
> Thanks in advance!
>
> Kind regards
> Thomas Rupp
> Vorarlberger Illwerke AG
> MAIL: [EMAIL PROTECTED]
> TEL: ++43/5574/4991-251
> FAX: ++43/5574/4991-820-8251
