There should have been a driver for your fiber card and some configuration
stuff for that and there should be an IBM driver for the drive. You
probably won't need the drive driver as I think ADSMSCSI supports the 3590
directly, but I could be wrong so check. There is a driver for the library
as well. I think both of those can be found on the ftp site under
/storage/devdrvr.
If you go into the TSM Utilities, Device Manager you should see the drives
and library there.
Kelly J. Lipp
Storage Solutions Specialists, Inc.
PO Box 51313
Colorado Springs CO 80949-1313
(719) 531-5926
Fax: (240) 539-7175
Email: [EMAIL PROTECTED] or [EMAIL PROTECTED]
www.storsol.com
www.storserver.com
-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:[EMAIL PROTECTED]]On Behalf Of
Rob Schroeder
Sent: Thursday, April 05, 2001 2:05 PM
To: [EMAIL PROTECTED]
Subject: Creating devices in Win2000
I have looked at the referred archive page and could not find what I was
looking for. Here is my environment:
Win2000 server running TSM 4.1 server on ehternet network and our SAN
3494 ATl connected via TCP/IP
3590E drive connected to the SAN via fibre within that ATL
My question:
How do I define a new tape library/tape drive to the 2000 server so that
the TSM server can see it? I have remote storage installed on the server,
but the device did not show up automatically. I assume I have a driver to
install, but could not find anyhting on IBM's web site.
Thanks in advance
Rob Schroeder
Famous Footwear
