Hi Guys! I've been studying my newly upgraded TSM (3.7.2 to 4.1.3) and noticed an anomoly that is different. And wondering if its B.A.D. or a bug that needs fixing. If I have a DISKPOOL at 86% migratable and I change the hi/low settings from 100/99 to 85/70 a migration proceess (or two) kicks off. No surprise there. If I do nothing else it will migrate to 70% migratable give or take a percentage point. Right? No surprise there. If I change the settings back to 100/99 it will do the largest users (be it 1,2,3...10 percent off) and then stop. As expected. Here's the B.A.D./bug: If I change the HI parm to 100 but leave the low at 70 it stops almost immediately. Even if the percentage is at some number greater than the low number (in this case 70) In other words its act like I changed it to 100/99!!!! Up to 3.7.2 the logic has always been observed in migrating down to the low number regardless of the hi setting. But now???? Has anyone else seen this? When did it change behaviour? Is it a bug or a 'new design feature'?? thanks! ... joe.f. Joseph A Faracchio, Systems Programmer, UC Berkeley Private mail on any topic should be directed to : [EMAIL PROTECTED]
