Hi
1. You don't have to have ACSLS software to run the L700. It's a standard
SCSI library.
2. There is no special way to configure the L700. You just configure it as
a standard SCSI library. Here are some hints:
- 9840 drives is configured as ECartridge drives
- You have to configure the L700 and define onbus and offbus drives(which
means drives that isn't on the same chain as the robotics is offbus).
- Drive 1 is the drive placed highest in the library, which mean that the
drive slot in the bottom is the last drive.
- Check the firmwarelevel. If I remember correctly, you have to have at
least firmware version 220(needs to be checked, it was sometime ago I
configured one of thoose).
Everything else is just standard configuration.
Best Regards
Daniel Sparrman
-----------------------------------
Daniel Sparrman
Exist i Stockholm AB
Bergk�llav�gen 31D
192 79 SOLLENTUNA
V�xel: 08 - 754 98 00
Mobil: 070 - 399 27 51
Jason Morgan
<jmorga31@CSC To: [EMAIL PROTECTED]
.COM> cc:
Sent by: Subject: StorageTek L700 config.
"ADSM: Dist
Stor Manager"
<[EMAIL PROTECTED]
RIST.EDU>
2002-01-28
17:14
Please
respond to
"ADSM: Dist
Stor Manager"
Hi,
I have been tasked with configuring a StorageTek L700 into a new TSM
environment.
The environment is as follows:-
TSM Server 4.1 running on AIX 4.3.3. TSM will eventually be upgraded to
4.2.1.
StorageTek Robot SCSI attached to Server.
6 9840 Drives fibre attached to Brockade Switch.
What I need to know is
1) Do you need ACSLS software from StorageTek to drive the library or does
TSM drive the Library ?
2) Can anyone supply the decvonfig files for this type of config or provide
any tips etc.. ?
Any help would be appreciated.
Regards Jason
