Thank you very much Joe for your answer, I will try this because I don't have the machine in this site. I try and then let you know. Regards.
Joe Cascanette
<Joe.Cascanette@C To: [EMAIL PROTECTED]
UMIS.COM> cc:
Sent by: "ADSM: Subject: Re: Tape Error
Dist Stor
Manager"
<[EMAIL PROTECTED]
.EDU>
30/01/2002 11:38
Please respond to
"ADSM: Dist Stor
Manager"
I had the same problem with my DLT8000 drives. I had one at the end of the
chain that had problems from the start. I checked the cables and all, but
nothing. I then went into the TSM Admin config gui, (deleted all the drives
first) and then readded them. Works fine now.. TSM server 4.2.1.6 on
Windows2000
Joe
-----Original Message-----
From: Christian Astuni [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, January 30, 2002 8:07 AM
To: [EMAIL PROTECTED]
Subject: Tape Error
Hi ...all
I have a question with the tapes. I have 4 Compaq DLT 7000 in TSM 4.2.1.9
in Windows NT. My server have only one SCSI adapter and only 3 of the 4 DLT
work fine, but one doesn't work. This tape work fine in Windows NT (NT
Backup). When I try to write I received this error messages:
ANR8302E I/O error on drive MT2 <MT2.0.0.1> <OP=WRITE, Error Number=1117,
CC=205, KEY=FF ASC,=FF ASCQ=FF,
SENSE=**NONE**
Description=SCSI adapter failure>. Refer to Appendix D in the 'Messages'
manual for recommended action.
ANR1411W Access mode for volume AD0002 now set to "read-only" due to write
error.
I found in the appendix D the messages and the only code that I found is
CC=205 and the explanation was:
"Check for loose cables, bent pins, bad cables, bad SCSI adapters, improper
termination or bad termination"
If one of this reasons are correctly, the tape doesn't work fine in NT
either or I'm wrong. ?
Thank you very much at all !!
Christian Astuni
IBM Global Services
[EMAIL PROTECTED]
Tel. 4898-4621
Hipolito Yrigoyen 2149 - Mart�nez (1640) Bs. As. - Argentina
