We've updated to 2.8.0.41 on our 3583, changed the barcode to extended. (Also checked in a cleaner cart in the previously reserved slot and set the library to auto cleaning - gains a slot!)
We've had a few problems since we've upgraded, since everything was running fine before this the firmware upgrade is suspicious. We've had 3 occurrences of the picker dropping a tape cartridge - twice the cartridge was on top of the picker (Once it was hiding underneath!) Since we had the problems, IBM has replaced the picker and a logic card - we had another tape dropped this morning. We decided late this afternoon to downgrade back to the level we were at and when we did, the library comes up but does not recognize any slots past column 2! So back to the new firmware and we're hoping we'll last the weekend (Long weekend in Canada - Rememberance Day) without any dropped cartridges. Tim Rushforth City of Winnipeg -----Original Message----- From: Coats, Jack [mailto:Jack.Coats@;BANKSTERLING.COM] Sent: November 8, 2002 7:19 PM To: [EMAIL PROTECTED] Subject: Re: q libv just stopped working? Got it working. ... When updating the microcode to 2.80.41 on the 3583 library, it sets the barcode length to 'normal' (6 CHARACTER) from 'extended' (8 character). After setting it to 'extended' I should have pulled all my tapes out of the library, inventoried the library, then check all the tapes back in. It took a while but it is now working! Why the cleaning tape? ... Don't know. ... JC > -----Original Message----- > Sent: Friday, November 08, 2002 4:45 PM > Subject: q libv just stopped working? > > we just upgraded our IBM3583 library. > > Things were going OK but all of a sudden q libv just stopped working. > > Only one volume ( a cleaning tape, is seen in the library ) ... bummer. > > Suggestions? > > TSM 4.1.3 on Windows NT4 SP6
