According to the Backing up DB2 PDF for backing up DB2 on Solaris, on page 92 step 2 it says:
2. The /etc/system must have, as a minimum, the following values. Modify them as necessary, then reboot. set lwp_default_stksize = 0x4000 set rpcmod:svc_run_stksize = 0x4000 set semsys:seminfo_semmap = 50 set semsys:seminfo_semmni = 50 set semsys:seminfo_semmns = 300 set semsys:seminfo_semmnu = 150 set semsys:seminfo_semopm = 50 set semsys:seminfo_semume = 50 set semsys:seminfo_semmsl = 125 The above svc_run_stksize parameter throws an error during Solaris boot that says something to the effect of it being an invalid parameter. Is this a typo in the book? Should it actually be svc_default_stksize? Looking at -> http://docs.sun.com/db/doc/806-6779/6jfmsfr7h?q=set+rpcmod <http://docs.sun.com/db/doc/806-6779/6jfmsfr7h?q=set+rpcmod&a=view> &a=view I don't see an svc_run_stksize Anyone? IBM?? Gerald Wichmann Senior Systems Development Engineer Zantaz, Inc. 925.598.3099 (w) This e-mail has been captured and archived by the ZANTAZ Digital Safe(tm) service. For more information, visit us at www.zantaz.com. IMPORTANT: This electronic mail message is intended only for the use of the individual or entity to which it is addressed and may contain information that is privileged, confidential or exempt from disclosure under applicable law. If the reader of this message is not the intended recipient, or the employee or agent responsible for delivering this message to the intended recipient, you are hereby notified that any dissemination, distribution or copying of this communication is strictly prohibited. If you have received this communication in error, please notify the sender immediately by telephone or directly reply to the original message(s) sent. Thank you.
