Kurt Thanks again!
regards, Tim Kurt Beyers wrote: > Thimoty, > > The 'wait=yes' is required to make sure that the process is started in the > foreground. If it is started in the background, the processes will be started > in parallel even with the SERIAL parameter in the script. I found this out > using it in a script that started multiple exports. As an export cannot be > started in the foreground, all of them started in parallel. > > If you know what backup session will be running as the last, you could start > an administrative schedule here as a post-exec command. But I guess that it > is hard to tell which job will finish as the last one. > > best regards, > Kurt > > ________________________________ > > Van: ADSM: Dist Stor Manager namens Timothy Hughes > Verzonden: ma 24/04/2006 20:39 > Aan: [email protected] > Onderwerp: [ADSM-L] New Migrate command > > Hello all, > > I have a question regarding the 5.3 Migrate Command I have the > command set up for > > Migrate stgpool backuppool lowmig=0 > > From what I read this command cannot be used with automatic > migration. I am assuming they mean it cannot run at the same time as > automatic migration? > > Also, I have House Keeping tasks that I have setup using the > Administrative command schedule sometimes, I have to adjust the > schedule several times a week so I am planning to implement the > script below with the new serial commands only. I want the tasks to > start only after the previous tasks are complete. I have tested this > already and it worked. my question is since the serial command is in > there is the wait=yes really necessary as shown in the admin manual > Also, is there a way to set this script up to start automatically after > the backup's end? > > /*script: Backuppool STGPOOL > > /* Backup Diskpool to tape*/ > > /* previous command must finish before proceeding > /* with next command in sequence/ > > Serial > BA STG backuppool R359XPOOL maxpr=xx preview=no wait=yes > > /* Start Disk pool migration*/ > Serial > > migrate stgpool backuppool lowmig=0 > > Serial > > /* Backup pool (L359Xpool) to R359Xpool*\ > > BA STG L359XPOOL R359XPOOL maxpr=xx preview=no wait=yes > > TSM 5.3.2 > > Thanks in Advance!
