How about "upd stg (stgpoolname) reuse=0" Bill
-----Original Message----- From: ADSM: Dist Stor Manager [mailto:[EMAIL PROTECTED] On Behalf Of Barbara Andrews Sent: Wednesday, February 21, 2007 2:53 PM To: [email protected] Subject: [ADSM-L] change in reusedelay value and time it take for tapes to change status When I set the reusedelay period for one of my tape storage pools to a lower value in order to force more tapes to go from pending status to empty, I notice that it can take anywhere from a few minutes to as much as an hour for the tapes to change status. I'm guessing this is because there is some interval set at which TSM checks on the resusedelay value. Does anybody know how/if this value can be changed so that I can make the interval shorter? Barbara Andrews, Systems Software Specialist ++++++++++++++++++++++++++++++++++++++++ Western New York Regional Information Center (716)821-7130 [EMAIL PROTECTED] ________________________________________________________________________ This inbound email has been scanned for all viruses by the MessageLabs SkyScan service. ________________________________________________________________________ ______________________________________________________________________ This outbound email has been scanned for all viruses by the MessageLabs Skyscan service. For more information please visit http://www.messagelabs.com/email ______________________________________________________________________
