Mel, In case it needs to run an AUDIT LIBRARY, would it be with CHELKLABEL=YES or CHECKLABEL=BARCODE? Because, CHECKLABEL=YES may take hours to complete the audit as it mounts and checks the label of each volume...
-Rama -----Original Message----- From: ADSM: Dist Stor Manager [mailto:[EMAIL PROTECTED] On Behalf Of Dennis, Melburn (IT Solutions US) Sent: Thursday, December 06, 2007 4:04 PM To: [email protected] Subject: Re: [ADSM-L] ANR8314E Library is Full Error Actually if all that was added was extra slots in the second frame, all that needs to be run is an "audit library" command. This will force your library to reaudit your current inventory including the new empty slots. If new drives were added as well, just define the new paths and drives to the existing library. No need to delete paths/drives/library for this. I've done it several times when we've upgraded our scalar 10k with new cabinets. Mel Dennis Backup Systems Engineer Siemens IT Solutions and Services, Inc. PGST Data Center Operations 4400 Alafaya Trail MC Q1-108 Orlando, FL 32826 Tel.: 407-736-2360 Mob: 321-356-9366 Fax: 407-243-0260 mailto:[EMAIL PROTECTED] www.usa.siemens.com/it-solutions -----Original Message----- From: ADSM: Dist Stor Manager [mailto:[EMAIL PROTECTED] On Behalf Of Stapleton, Mark Sent: Thursday, December 06, 2007 2:44 PM To: [email protected] Subject: Re: [ADSM-L] ANR8314E Library is Full Error From: ADSM: Dist Stor Manager [mailto:[EMAIL PROTECTED] On Behalf Of Maura Adams > Thanks for the info. I just heard back from IBM support and because our > second frame to the library was added after our original install, TSM > does not see it. We need to take an outage and delete/define all paths, > library, drives and check all tapes back in. A little bit ugly. Not ugly at all, and no outage is required if you do this at night, since tape drives are usually quiet during that time anyway. Write a batch file that does the following: delete path (all tape drives) delete path (for library) delete drive (all tape drives) delete library (library) define library define path (for library) define drive (all tape drives) define path (all tape drives) checkin libv (library) search=yes status=scratch checkl=barcode checkin libv (library) search=yes status=private checkl=barcode Call the batch file "library_redo". Run the file as a macro. This should all run within a minute or two. Do it while all tape drives are quiet. -- Mark Stapleton Berbee (a CDW company) System engineer 7145 Boone Avenue North, Suite 140 Brooklyn Park MN 55428-1511 763-592-5963 www.berbee.com -------------------------------------------------------- This message w/attachments (message) may be privileged, confidential or proprietary, and if you are not an intended recipient, please notify the sender, do not use or share it and delete it. Unless specifically indicated, this message is not an offer to sell or a solicitation of any investment products or other financial product or service, an official confirmation of any transaction, or an official statement of Merrill Lynch. Subject to applicable law, Merrill Lynch may monitor, review and retain e-communications (EC) traveling through its networks/systems. The laws of the country of each sender/recipient may impact the handling of EC, and EC may be archived, supervised and produced in countries other than the country in which you are located. This message cannot be guaranteed to be secure or error-free. This message is subject to terms available at the following link: http://www.ml.com/e-communications_terms/. By messaging with Merrill Lynch you consent to the foregoing. --------------------------------------------------------
