After running the command in the previous message to change the log mode, you should run a full database backup so that the change will take effect completely.
If you change to roll forward mode, it's probably a good idea to also define a DBBACKUPTRIGGER (DEFine DBBackuptrigger), as Bad Things may happen if your recovery log fills up (and it is more likely to do so in roll forward mode than normal mode). --Todd Sandeep Jain wrote:
Yes you can... >set logmode rollforward Regards, Sandeep Jain TSM Specialist -----Original Message----- From: ADSM: Dist Stor Manager [mailto:[EMAIL PROTECTED] On Behalf Of Kiran Sent: Tuesday, September 30, 2008 12:50 PM To: [email protected] Subject: [ADSM-L] Recover log Mode... Hi, Can I change recovery log mode from normal to roll forward? Are there any dependencies in doing this? Regards, Kiran M Disclaimer: This email message (including attachments if any) may contain privileged, proprietary, confidential information, which may be exempt from any kind of disclosure whatsoever and is intended solely for the use of addressee (s). If you are not the intended recipient, kindly inform us by return e-mail and also kindly disregard the contents of the e-mail, delete the original message and destroy any copies thereof immediately. You are notified that any dissemination, distribution or copying of this communication is strictly prohibited unless approved by the sender. DQ Entertainment (DQE) has taken every reasonable precaution to minimize the risk of transmission of computer viruses with this e-mail; DQE is not liable for any damage you may sustain as a result of any virus in this e-mail. DQE shall not be liable for the views expressed in the e-mail. DQE reserves the right to monitor and review the content of all messages sent to or from this e-mail address
-- Todd D. Taft [EMAIL PROTECTED]
