If your TSM server runs Windows, go to the Setup Wizard under Label Media. Using the wizard there will only label one tape at a time, but it will make use of all the tape drives at once, rather than one at a time. That's a much faster process. -- Mark Stapleton ([EMAIL PROTECTED]) CDW Berbee System engineer 7145 Boone Avenue North, Suite 140 Brooklyn Park MN 55428-1511 763-592-5963 www.berbee.com
> -----Original Message----- > From: ADSM: Dist Stor Manager [mailto:[EMAIL PROTECTED] On Behalf > Of Andrew Collyer > Sent: Thursday, November 13, 2008 10:36 AM > To: [email protected] > Subject: [ADSM-L] Labelling mass volume of tapes with Label Libvol > > Hi, > > I have a new TS3500 library with 2500 scratch tapes. I'm running a > LABEL > LIBVOL command within TSM 5.5.1.1 but unfortunately it is labelling one > tape at a time. I'm using the barcode as the source. > > Is there a way to label more than one tape at a time? It's a good > waste of > time and plenty of drives! > > Thanks. > > Andrew > > ----------------------------------------- > Find out about our efforts to create gardens in Yorkshire's primary > schools using a million green fingers by following this link: > http://greenfingers.yorkshirewater.com/ > > The information in this e-mail is confidential and may also be > legally privileged. The contents are intended for recipient only > and are subject to the legal notice available at > http://www.keldagroup.com/email.htm Yorkshire Water Services > Limited > Registered Office Western House Halifax Road Bradford BD6 2SZ > Registered in England and Wales No 2366682
