I have 6.1.6 XM running and am not experiencing that issue.I rebooted it
last week at which time it had been up almost two months, with clients
connected for 50+ days.
On 06/27/2018 12:40 PM, Timothy Steele wrote:
It will kick client off the AP you need to use the old 5.5 firmware
On Wed, Jun 27, 2018, 12:58 PM Sam Morris <[email protected]
<mailto:[email protected]>> wrote:
What's up with the 900 Mhz and latest firmware?
On 06/21/2018 11:01 PM, Timothy Steele wrote:
> Sounds like interference issue latest firmware is very solid
unless your
> running 900mhz
>
> On Thu, Jun 21, 2018, 5:22 PM Jason McKemie
> <[email protected]
<mailto:[email protected]>
> <mailto:[email protected]
<mailto:[email protected]>>> wrote:
>
> I'm having a bit of a head-scratcher here. I've got a Ubiquiti
> Nanostation that I'm using as an AP for a small repeater
site. All
> of the CPE's attached to it dropped in TX signal strength by
about
> 15-20db. I tried switching the Nanostation out thinking maybe it
> was going deaf, but the problem persisted. Then I tried
switching
> to the opposite end of the band (was at the low end).
Problem went
> away. Is there something I'm not aware of from a regulatory
> standpoint that has been added in newer firmware or is this a
bug?
> It didn't seem to have nearly as much of an effect on the
AP's TX,
> so I'm leaning towards a bug.
>
> -Jason
> --
> AF mailing list
> [email protected] <mailto:[email protected]> <mailto:[email protected]
<mailto:[email protected]>>
> http://af.afmug.com/mailman/listinfo/af_af.afmug.com
>
>
>
--
AF mailing list
[email protected] <mailto:[email protected]>
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
--
AF mailing list
[email protected]
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
