Sure, you can also wash them with 90% isopropyl alcohol. That will remove any water. Need to make sure there is no corrosion. Wash out the jacks extra good too.
If they have not had too large of a surge, they are totally self resetting. From: Josh Luthman Sent: Tuesday, September 11, 2018 7:25 AM To: AFMUG Subject: [AFMUG] Surge suppression failure gigE APC HV There's a cause and I'm pretty confident it's not the cards themselves. This weekend an AP started having eth link issues. Look at it and the card/rj45 is full of water. Replaced the line. Problem returns about 12 hours later. I plug in my continuity tester and pin 7 blinks quickly and fades away. Headed up the tower now for a new AP and already did a new Poe (no power until AP replaced). Is it possible the Poe/AP are damaging the surge card? We've gone through 5-6 cards since Saturday, and I thought it was all water related. It stopped raining on Sunday after card 3 + new line. Any other ideas? Can I wait a minute and reuse the dry cards, are they self resetting (I tried power cycling the POE for 5 seconds with no change) after a length of time? Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 -------------------------------------------------------------------------------- -- AF mailing list [email protected] http://af.afmug.com/mailman/listinfo/af_af.afmug.com
-- AF mailing list [email protected] http://af.afmug.com/mailman/listinfo/af_af.afmug.com
