Sounds like alignment/aiming mode is still enabled at one end - IIRC it would be the other end. Also check the signal strength ratio under statistics, make sure it's close to 0 and not ~ +-30db which would mean a transmitter or receiver may be bad at one end.
On Mon, Oct 15, 2018 at 10:41 AM Sam Lambie <[email protected]> wrote: > Hey all, > > I installed a new set of PTP 650 last week. Using the arming tones and > signal graphs, we got the link as dialed in as we could. Both sides are > showing -58ish but one side is only showing single chain at 16QAM-QPSK. > [image: Screen Shot 2018-10-15 at 9.37.16 AM.png] > I don't think that I am on a side lobe, but anything is possible. Any > suggestions on how better to troubleshoot this link? > > -- > -- > *Sam Lambie* > Taosnet Wireless Tech. > 575-758-7598 Office > www.Taosnet.com <http://www.newmex.com> > -- > AF mailing list > [email protected] > http://af.afmug.com/mailman/listinfo/af_af.afmug.com >
-- AF mailing list [email protected] http://af.afmug.com/mailman/listinfo/af_af.afmug.com
