One of my colleagues suggested that approach. I haven't ruled it out.
On 1/3/2019 4:46 PM, Louis Arsenault wrote:
If it were me I would just splice on a pigtail and put a splice chip
double side taped to the inside like these.
http://www.tiitech.com/repository/datasheetlibrary/FET2.pdf
On Thu, Jan 3, 2019 at 4:17 PM <[email protected]
<mailto:[email protected]>> wrote:
Gotta love the sticky gel seal rubber. Best stuff out there.
-----Original Message-----
From: Adam Moffett
Sent: Thursday, January 3, 2019 2:00 PM
To: [email protected] <mailto:[email protected]>
Subject: [AFMUG] Drop Termination Closures
Commscope and Multilink both make aerial closures like this.
Even if I take 10 minutes to put a connector on the cable, that's
still
faster than taking a closure off the strand, bringing it down into
your
truck/trailer, break the seal, fusion splice, reseal, rehang,
re-tie the
slack.
They intend for you to use preterminated cables, but I think that
has to
come with a lot of waste so I'm not 100% sold on that. That's why I'm
experimenting with terminations on drop cables.
I suppose I seek comment on both the termination process and also
whether this is a stupid idea to start with.
-Adam
--
AF mailing list
[email protected] <mailto:[email protected]>
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
--
AF mailing list
[email protected] <mailto:[email protected]>
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
--
-Louis
NTInet
O: 803-533-1660 X 207
C: 803-997-0004
--
AF mailing list
[email protected]
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
