>From my AF5 and AF5/AF5HD snmpwalk notes. You should be able to build a cacti data acquisition and chart template from this.
ubnt af5 snmp mib notes, the most important items to poll based on snmpwalk of firmware v3.2.3 radio radio board uptime in seconds myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.2.1.38.1 .1.3.6.1.4.1.41112.1.3.2.1.38.1 = INTEGER: 4951 radio is enabled yes or no, 1=enabled, 2=disabled myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.1.1.2.1 .1.3.6.1.4.1.41112.1.3.1.1.2.1 = INTEGER: 1 radio link state, 0=down, 1=up myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.2.1.26.1 .1.3.6.1.4.1.41112.1.3.2.1.26.1 = INTEGER: 1 radio link uptime in seconds myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.2.1.44.1 .1.3.6.1.4.1.41112.1.3.2.1.44.1 = INTEGER: 2537 radio mode master or slave, 1=master, 2=slave, 3=spectrum analysis myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.1.1.3.1 .1.3.6.1.4.1.41112.1.3.1.1.3.1 = INTEGER: 1 gps satellites visible myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.2.1.34.1 .1.3.6.1.4.1.41112.1.3.2.1.34.1 = INTEGER: 6 gps satellites being tracked myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.2.1.35.1 .1.3.6.1.4.1.41112.1.3.2.1.35.1 = INTEGER: 8 gps sync status, 1=off, 2=yes myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.1.1.8.1 .1.3.6.1.4.1.41112.1.3.1.1.8.1 = INTEGER: 2 radio link distance in meters myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.2.1.4.1 .1.3.6.1.4.1.41112.1.3.2.1.4.1 = INTEGER: 8159 radio0 temperature in c myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.2.1.8.1 .1.3.6.1.4.1.41112.1.3.2.1.8.1 = INTEGER: 32 radio1 temperature in c myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.2.1.10.1 .1.3.6.1.4.1.41112.1.3.2.1.10.1 = INTEGER: 46 radio duplex mode, 1=halfduplex, 2=fullduplex myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.1.1.4.1 .1.3.6.1.4.1.41112.1.3.1.1.4.1 = INTEGER: 2 radio tx frequency in MHz myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.1.1.5.1 .1.3.6.1.4.1.41112.1.3.1.1.5.1 = INTEGER: 5666 radio rx frequency in MHz myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.1.1.6.1 .1.3.6.1.4.1.41112.1.3.1.1.6.1 = INTEGER: 5709 radio tx power myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.1.1.9.1 .1.3.6.1.4.1.41112.1.3.1.1.9.1 = INTEGER: 30 radio rx gain setting, 1=low, 2=high myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.1.1.10.1 .1.3.6.1.4.1.41112.1.3.1.1.10.1 = INTEGER: 2 radio max modulation setting, 0=qpsk, 8=256qam myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.1.1.11.1.1 .1.3.6.1.4.1.41112.1.3.1.1.11.1 = INTEGER: 8 radio current tx modulation rate 0=qpsk siso 2=qpsk mimo 4=16qam mimo 6=64qam mimo 8=256qam mimo myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.2.1.2.1 .1.3.6.1.4.1.41112.1.3.2.1.2.1 = INTEGER: 6 radio current rx capacity in bits per second (divide by 1000000 to get Mbps) myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.2.1.5.1 .1.3.6.1.4.1.41112.1.3.2.1.5.1 = INTEGER: 148446720 radio current tx capacity in bits per second (divide by 1000000 to get Mbps) myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.2.1.6.1 .1.3.6.1.4.1.41112.1.3.2.1.6.1 = INTEGER: 214749440 radio rx power rsl chain 0 myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.2.1.11.1 .1.3.6.1.4.1.41112.1.3.2.1.11.1 = INTEGER: -74 radio rx power rsl chain 1 myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.2.1.14.1 .1.3.6.1.4.1.41112.1.3.2.1.14.1 = INTEGER: -74 radio tx frames OK myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.3.1.2.1 .1.3.6.1.4.1.41112.1.3.3.1.2.1 = Counter64: 144530 radio rx frames OK myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.3.1.3.1 .1.3.6.1.4.1.41112.1.3.3.1.3.1 = Counter64: 0 radio tx errored frames myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.3.1.11.1 .1.3.6.1.4.1.41112.1.3.3.1.11.1 = Counter64: 12 radio rx frames with crc error myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.3.1.4.1 .1.3.6.1.4.1.41112.1.3.3.1.4.1 = Counter64: 0 radio rx frames with alignment error myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.3.1.5.1 .1.3.6.1.4.1.41112.1.3.3.1.5.1 = Counter64: 0 radio rx errored frames myworkstationhostname:~ erickuhnke$ snmpwalk -v1 -O n -c mysnmpcommunitystring ip.of.my.af5.radio .1.3.6.1.4.1.41112.1.3.3.1.10.1 .1.3.6.1.4.1.41112.1.3.3.1.10.1 = Counter64: 0 On Thu, Jan 17, 2019 at 2:29 PM dave <[email protected]> wrote: > something comes to mind... Oh yeah PTP550 :) > > > On 1/17/19 1:48 PM, Josh Luthman wrote: > > 1.1.1 is one set of OIDs > 1.1.2 is another set of OIDs (and it lost some capabilities from 1.1.1) > > There's a MIB on the website that sucks. > > I've been emailing them back/forth about this so we can get a useful MIB > like we had/have with af5x for months. > > Josh Luthman > Office: 937-552-2340 > Direct: 937-552-2343 > 1100 Wayne St > Suite 1337 > Troy, OH 45373 > > > On Thu, Jan 17, 2019 at 10:30 AM Zack Deveaux <[email protected]> > wrote: > >> Has anyone made Cacti templates/Data Queries for Airfiber 5XHD radios? >> They use a different MIB than the other AirFiber radios and the OIDs for >> the main radio values seem to be indexed, so differ based on which link I'm >> graphing. I'm not great with creating xml/Data Queries in Cacti, hoping >> someone has already gone through the pain and is willing to share. >> >> -Zack D >> -- >> AF mailing list >> [email protected] >> http://af.afmug.com/mailman/listinfo/af_af.afmug.com >> > > -- > -- > AF mailing list > [email protected] > http://af.afmug.com/mailman/listinfo/af_af.afmug.com >
-- AF mailing list [email protected] http://af.afmug.com/mailman/listinfo/af_af.afmug.com
