Just found out about POE Texas, will be ordering some of their stuff soon. I’m interested in powering mikrotik RB4011 so I guess a 1A might cover it, but like to be able to give more power with 24v.
From: AF <[email protected]> On Behalf Of Colin Stanners Sent: Wednesday, February 13, 2019 8:39 PM To: AnimalFarm Microwave Users Group <[email protected]> Subject: Re: [AFMUG] Looking for PS and POE He may be doing similar to what our ham radio HSMM group did for some cost-effective setups, one (or 2 redundant, using a diode device) 24V supply feeding a 5$ standard 1:4 to 1:8 DC splitter (used for security camera systems) then to PoE injectors. We're doing that for Ubnt/MT radios using 4$ 100mbit offbrand injectors and it's nice way to have something small and DC, with some redundancy, for cheap. On Wed, Feb 13, 2019, 9:24 PM Ken Hohhof <[email protected]<mailto:[email protected]> wrote: What are you powering? 24V at 1.8A is way more than most CPE, but most gigabit APs and backhauls want 48V not 24V. Also not sure why you want a separate wall wart and a round DC power plug rather than injector and power supply in one with an AC cord. There’s also the question of whether you’re looking for passive or 802.3af with signature detection and a status light. But you’d think between Tycon and POE Texas you could find whatever you want. From: AF <[email protected]<mailto:[email protected]>> On Behalf Of Colin Stanners Sent: Wednesday, February 13, 2019 8:45 PM To: AnimalFarm Microwave Users Group <[email protected]<mailto:[email protected]>> Subject: Re: [AFMUG] Looking for PS and POE For gigabit PoE injector it all depends on the pinout that you need - what pinout/radio do you want to power? Why do the manufacturer solutions not work? For PS, do you need plastic-case "consumer" PSU or is a semi-open-frame OK? On Wed, Feb 13, 2019, 7:29 PM Sterling Jacobson <[email protected]<mailto:[email protected]> wrote: I’m looking for a new/good supplier of a Gigabit POE injector that has the female DC receptacle on it and is known to work well. Also looking for good PS too, 24v around 1.8A would be nice, again with the round DC male end on about 6’ cord from a wall wart is fine. For some reason can’t seem to find a good vendor of either of those items, that are known good over time and decent price. -- AF mailing list [email protected]<mailto:[email protected]> http://af.afmug.com/mailman/listinfo/af_af.afmug.com -- AF mailing list [email protected]<mailto:[email protected]> http://af.afmug.com/mailman/listinfo/af_af.afmug.com
-- AF mailing list [email protected] http://af.afmug.com/mailman/listinfo/af_af.afmug.com
