you could use UPC2 https://www.sitepro1.com/store/cart.php?m=product_list&c=63
With a set of crossovers https://www.sitepro1.com/store/cart.php?m=product_list&c=64 The wide side of the UPC2 just put the all thread tight to the sides of the beam, assuming its a horizontal beam(s) if there arent two beams to get the verical pipe between then this would get super cobbled with stabilizers On Wed, Apr 3, 2019 at 12:19 PM Jeremy <[email protected]> wrote: > I have to build a large standoff off each side of a 6" x 6" square steel > beam for backhauls. I can think of a few ways to make it with all-thread > and metal, but I am concerned about slippage if it does not conform to the > two edges of the beam (not sure if you are following me here). I was > wondering if there is a commercially-available bracket already made for > this. Anyone seen anything like this for mounting to square pipe? You > don't make something like this, do you Chuck? > -- > AF mailing list > [email protected] > http://af.afmug.com/mailman/listinfo/af_af.afmug.com >
-- AF mailing list [email protected] http://af.afmug.com/mailman/listinfo/af_af.afmug.com
