Normally, the -A would designate Andrew (see here) https://www.scribd.com/document/348184480/Andrew-Antenna-Specs
But, it really doesn’t matter - the whole reason for selling these as “Dragonwave” antennas is they controlled the flange or mount. I believe that CommScope and RW were not allowed to sell the mount directly, and you had to go through DW to get it. The specs on this antenna list it as single polarized, and you’ll have to look at the feedhorn to see what you have here. If it’s not circular, you will have to get a dual-polarized feedhorn. I’m not up to speed on Chuck’s adaptor, but you may have to remove the DW flange or mount to get this to work properly with it. Hopefully an OMT is included somewhere in here? https://www.solidsignal.com/pview.asp?p=a-ant-11g-36-c Sent from my iPad > On Jul 3, 2019, at 10:04 PM, Keefe John <kj...@ethoplex.com> wrote: > > The antenna model is A-ANT-11G-36-C-A > > Keefe > >> On Wed, Jul 3, 2019, 8:52 PM Keefe John <kj...@ethoplex.com> wrote: >> These are the radiowaves ones. >> >>> On Wed, Jul 3, 2019, 5:41 PM Chuck McCown <ch...@wbmfg.com> wrote: >>> Good point. Has to be circular waveguide on the antenna. >>> >>> Sent from my iPhone >>> >>>> On Jul 3, 2019, at 4:27 PM, Tim Hardy <thardy...@gmail.com> wrote: >>>> >>>> Dragonwave never made antennas - they private labeled either Commscope >>>> ValueLine or RadioWaves antennas. These would require an OMT or >>>> dual-polarized feeds to get both polarizations. >>>> >>>>> On Jul 3, 2019, at 10:27 AM, Keefe John <kj...@ethoplex.com> wrote: >>>>> >>>>> The TX power is correct. >>>>> >>>>> We'll double check the tightness but the techs said they didn't see an >>>>> issue when installed. >>>>> >>>>> It is possible the leads are switched at one end, however you are correct >>>>> Chuck that UBNT claims that doesn't matter with this radio. >>>>> >>>>> Is anyone sure the Dragonwave dishes actually work with two polarities at >>>>> once? I believe the literature says single pol. I know they are dual >>>>> pol in that you can connect a Dragonwave either horizontally or >>>>> vertically on the back of the dish but can you use two polarities at once? >>>>> >>>>> Keefe >>>>> >>>>> Keefe John >>>>> CEO >>>>> Ethoplex >>>>> Direct: 262.345.5200 >>>>> -------------------- >>>>> Ethoplex Business Internet >>>>> http://www.ethoplex.com/ >>>>> Signal Residential Internet >>>>> http://www.signalisp.com/ >>>>> >>>>> https://www.linkedin.com/in/keefejohn/ >>>>> >>>>> >>>>>> On Wed, Jul 3, 2019 at 8:56 AM Chuck McCown <ch...@wbmfg.com> wrote: >>>>>> Both chains and both directions? Cross pol would be about 20db down but >>>>>> doesn’t that radio automagically take care of that for you? >>>>>> >>>>>> Sent from my iPhone >>>>>> >>>>>> > On Jul 3, 2019, at 7:24 AM, Keefe John <kj...@ethoplex.com> wrote: >>>>>> > >>>>>> > We took a Dragonwave Horizon Compact Pluses off a link and used >>>>>> > Chuck's adapters to install AF-11FXs on the Dragonwave dishes. Now >>>>>> > we're seeing a 20 Db signal loss on the RSL. The DSL with the original >>>>>> > Dragonwaves was 1 or 2 db off the PCN. What could be the problem? >>>>>> > >>>>>> > Keefe >>>>>> > -- >>>>>> > AF mailing list >>>>>> > AF@af.afmug.com >>>>>> > http://af.afmug.com/mailman/listinfo/af_af.afmug.com >>>>>> >>>>>> -- >>>>>> AF mailing list >>>>>> AF@af.afmug.com >>>>>> http://af.afmug.com/mailman/listinfo/af_af.afmug.com >>>>> -- >>>>> AF mailing list >>>>> AF@af.afmug.com >>>>> http://af.afmug.com/mailman/listinfo/af_af.afmug.com >>>> >>>> -- >>>> AF mailing list >>>> AF@af.afmug.com >>>> http://af.afmug.com/mailman/listinfo/af_af.afmug.com >>> -- >>> AF mailing list >>> AF@af.afmug.com >>> http://af.afmug.com/mailman/listinfo/af_af.afmug.com > -- > AF mailing list > AF@af.afmug.com > http://af.afmug.com/mailman/listinfo/af_af.afmug.com
-- AF mailing list AF@af.afmug.com http://af.afmug.com/mailman/listinfo/af_af.afmug.com
