It looks like you can't connect a new device to CNMaestro unless it's a
minimum 3.5.6, so I have to manually upgrade everything to get it to
that point to enter it in. Interesting is that radios running 3.5.1
that were already in CNMaestro are still connected and can be upgraded.
On 3/24/2020 12:02 PM, dave wrote:
I had seen this very same thing.. What I found out was the firmware on
the ap was in the 2.6 range and jumping to 3.56 I believe may have
caused the hiccup.
Not 100% on that but it was the only thing I could see that was
different because the others had 3.15 on them
On 3/24/20 11:56 AM, Nate Burke wrote:
I have used CNMaestro before, mainly for controlling E4XX AP's, but
I'm just starting to get back into it now for more network
management/upgrades. I was adding one of my EPMP sites in and
upgrading firmware via CNMaestro. One of the 4 AP's at a site reset
itself to Default when the firmware updated from CNMaestro, the other
3 AP's were fine. I had already manually updated the firmware to
3.5.6 so that it could connect to CNMaestro, so everything had been
recently rebooted. Has anyone seen this before? This was a batch
upgrade where I told it to update all the AP's and SM's, and only 1
defaulted. Now I'm a little wary of putting some of my bigger sites in.
--
AF mailing list
AF@af.afmug.com
http://af.afmug.com/mailman/listinfo/af_af.afmug.com
