Assuming a base II.... It should show you those values. But if for some reason it doesn't, If you need to figure it out, basically the first part of the OID is the same for all of the values in the column, and the last value changes from row to row and should match the index value shown in the first column.
A base 3 doesn't currently have the Hover functionality, and has different OIDS than the base II, BUT also has a full-fledged SNMP MIB which you can load which will make things a lot easier to understand where things are at. On Fri, Dec 18, 2020 at 2:59 PM Nate Burke <[email protected]> wrote: > It's been a while since I setup a new sitemonitor unit, Everything that > I have has been humming along for years. > > I'm trying to figure out the SNMP OID to set some values. When I hover > over the values on the base unit, it shows me the OID in the bottom of > the browser, but it's not displaying me anything when I hover over the > values on the expansion board (4 relay board) Am I missing something? > The values are all there in the Binary I/O, and I can turn the relays on > and off from the web page, but no OID displays when I hover over them. > All of the values from the base unit on the Analog I/O tab show me the > OID just fine. > > > > > > -- > AF mailing list > [email protected] > http://af.afmug.com/mailman/listinfo/af_af.afmug.com > -- - Forrest
-- AF mailing list [email protected] http://af.afmug.com/mailman/listinfo/af_af.afmug.com
