Im not doing anything, this is a not my chair not my problem issue. This strike blew everything on the tower, if it was electronic, it cooked, the switch was sitting on back of the APC and welded to it even tripped the breaker
Im just curious with these if theres any issue with the ATPC on these bas boys On Tue, Sep 23, 2014 at 4:42 PM, David via Af <[email protected]> wrote: > Inspect the cables or at lease switch one or both out at one end and see > if a prevalent change is made. > Could be a feed horn but unlikely I would shoot for pigtails first. > > > On 09/23/2014 02:38 PM, That One Guy via Af wrote: > > I just got done troubleshooting a 650 link for our landlord we are coloed > with on a couple towers. I had not looked at the ptp interface since the > 500. > > This thing is freaking beautiful, and I never compliment anybody, > especially on a web gui. > > Sooooo much information, so easy to find. > > > one question though, They have atpc set to -35 on these, does that > basically turn atpc off, or could it cause a problem? > > Im pretty sure they have a loose antenna or damaged feedhorn/patch > cables (this was a lighnting replacement of a ptp500, reusing the > cables/feedhorn) > > The system statistics showed a variation of received power ranging from > -47 to -78 with a peak of -110 , -78ish being current. Transmit powers show > a variation of -15dBm up to 21 dBm (I did not notice the negative value at > first). This would account for the range of Received power except When > the Status screenshots were taken, the transmit power on both units was at > 21 dBm with a 77/78 receive power on each side. If the output power is > accurate, the receive power on the remote end would be at the peak, not the > mean. > > -- > All parts should go together without forcing. You must remember that the > parts you are reassembling were disassembled by you. Therefore, if you > can't get them together again, there must be a reason. By all means, do not > use a hammer. -- IBM maintenance manual, 1925 > > > -- All parts should go together without forcing. You must remember that the parts you are reassembling were disassembled by you. Therefore, if you can't get them together again, there must be a reason. By all means, do not use a hammer. -- IBM maintenance manual, 1925
