Yes, I have a sector loaded that needed MIMO-A. And I found some minor
GUI issues and the Moto binary data GPS bug that has now been fixed in
build 32. But obviously I don't have things configured like others, such
as PPPoE, NAT, VLANs, etc. I just do bridge, no auth/RADIUS, very few
APs doing VLAN. So I would encourage more folks to test it out and give
feedback to Cambium so they can get any remaining issues ironed out and
get 13.2 official out. From the improvements I've seen so far, I want it
on every 450 AP and SM, right meow!
On 10/3/2014 9:55 PM, Bill Prince via Af wrote:
On 13.2 already George?ן¿½ I am happy to let you others get the
bleeding done before I step over the edge.
I think I will wait about a week before I give it a rip; and then only
only low-population APs.
bp
On 10/3/2014 6:28 PM, George Skorup (Cyber Broadcasting) via Af wrote:
I was just discussing with Aaron offlist about build 32 AutoSync
selecting the on-board GPS instead of timing port at boot. The
deployed AP I have been testing on has a Parasitic SyncPipe, no power
port sync and the iGPS on this AP usually always has a good lock.
Prior to build 32, it would always boot up and use the timing port.
Now build 32 wants the on-board at boot, at least every time I've had
a chance to reboot the AP, which has only been the update from build
30 to 32 and one reboot afterwards so far.
I would like to know if anyone else sees the same thing happening
with build 32. Maybe it's just me, but I would prefer it to come up
on the timing port before the on-board GPS for tracking GPS status of
the attached SyncPipe.
BTW, I've seen a very nice improvement in 13.2 beta for both
throughput and session issues during multipath events. I think 13.2
is going to be a major leap forward for the 450.
On 10/3/2014 6:19 PM, Aaron Schneider via Af wrote:
Since the last Open Beta load (Build 30), this also contains:
ן¿½
* Fix for negative VC count on home page
* New OID to see NAT table size in use
* Fix for Active FTP with NAT
* PPPoE Control Message High Priority with VLAN Enabled
ן¿½ן¿½ן¿½ן¿½ן¿½ן¿½ן¿½ן¿½ Added missing OIDs for IPv6 packet
filtering configuration
ן¿½
We are very close to release, so please give this load a try!
ן¿½
Regards,
ן¿½
-Aaron
ן¿½
*From:*Af [mailto:[email protected]] *On Behalf Of *John Mehling
via Af
*Sent:* Friday, October 03, 2014 6:10 PM
*To:* [email protected]
*Subject:* [AFMUG] 13.2 (Build32) Beta Software is Now Available!ן¿½ן¿½
ן¿½
Folks,
Software version 13.2(Build32) has been added to the Cambium Open
Beta program for PMP450, PMP430, and PTP230.
Please go here:ן¿½https://support.cambiumnetworks.com/betaן¿½if you
would like to test the new load and offer feedback on the Beta Forum.
ן¿½Fixes in this release include:
ן¿½ן¿½ן¿½ן¿½ן¿½ן¿½ן¿½ן¿½ן¿½ן¿½ן¿½ן¿½ן¿½ Fix for Motorola Binary GPS
based devices (CMM2, SyncPipe, etc)
ן¿½ן¿½ן¿½ן¿½ן¿½ן¿½ן¿½ן¿½ן¿½ן¿½ן¿½ן¿½ן¿½ Fix for PTP450 link test
with small packets causing session drop and/or invalid readings
ן¿½
This version also adds OID support for IPv6 packet filtering.
As always, we look forward to your feedback.ן¿½ Thank you!
-John
ן¿½
ן¿½
*John Mehling*
Senior Engineer - Support
*Cambium Networks*
3800 Golf Rd.,ן¿½ Suite 360
Rolling Meadows, IL 60008
www.cambiumnetworks.com
v_large_blue_noBG.png
ן¿½
