...
I may or maynot have done the exact same thing about 6 months ago.
I can "imagine" it would make quite a mess/stink...
Josh Reynolds, Chief Information Officer
SPITwSPOTS, www.spitwspots.com <http://www.spitwspots.com>
On 10/16/2014 01:35 PM, That One Guy via Af wrote:
I know a guy (looking at shoes) who may have dumped a quart of motor
oil into a conduit once
On Thu, Oct 16, 2014 at 2:22 PM, Chuck McCown via Af <[email protected]
<mailto:[email protected]>> wrote:
What is the diameter of the pipe?
I prefer to tie a plastic baggie to a lightweight pull string,
then use a shop vacuum to suck it through.
Then use the string to pull the wire.
-----Original Message----- From: cstanners--- via Af
Sent: Thursday, October 16, 2014 12:48 PM
To: [email protected] <mailto:[email protected]>
Subject: [AFMUG] Lubricant for pulling wire in conduit?
I'm at a residential customer install and I may have bitten off
more than I can chew - I agreed to attempt to install on their
garage and pull wire to their house through a pipe (since they
have a metal roof the only other place I can install is on the
front of their house - ugly).
It's taking forever to pull that wire due to friction/ angles, and
the shop has no wire-pulling "butter". Would dish soap work or is
there something else easily available?
--
All parts should go together without forcing. You must remember that
the parts you are reassembling were disassembled by you. Therefore, if
you can't get them together again, there must be a reason. By all
means, do not use a hammer. -- IBM maintenance manual, 1925
