I'd take the projector to radio shack if at all possible and have a go with the adaptaplug plugs. They often have a set of wires with the ends on them to try until one fits. I'm guessing size H.
http://www.radioshack.com/enercell-adaptaplug-h/2730340.html The inside diameter is almost always more critical than the outside. The H is a 1.3mm inside, 3.4mm outside diameter plug. That can then be mated with something like: http://www.radioshack.com/enercell-adaptaplug-power-cord-6-ft-/2730348.html#start=26&q=adaptaplug&sz=12 If that isn't an option, I'd try a 1.3x3.5mm plug which is a standard size. The hole for a 3.5 plug is typically around 4mm, which might be why they're confused. See: http://www.allelectronics.com/make-a-store/item/cb-310/6-cable-with-1.3mm-coax-power-plug/1.html http://www.allelectronics.com/make-a-store/item/dcp-13/1.3mm-dc-co-ax-power-plug/1.html http://www.mouser.com/ProductDetail/Kobiconn/171-3209/?qs=sGAEpiMZZMtnOp%252bbbqA00%252brH%252bGhOEZAajCNZHgLVdrw%3d On Sun, Nov 16, 2014 at 8:37 AM, Mike Hammett via Af <[email protected]> wrote: > Does anyone know where I can find "a standard 4.0 x 1.3mm 12 Volt power > port", preferably with a pigtail? It's for the screen trigger output on an > InFocus projector. That's what InFocus support said I needed to use and > that it's available in any local electronics store. Well, it's not at Radio > Shack. Google sure isn't being a lot of help either. > > > > ----- > Mike Hammett > Intelligent Computing Solutions > http://www.ics-il.com > > <https://www.facebook.com/ICSIL> > <https://plus.google.com/+IntelligentComputingSolutionsDeKalb> > <https://www.linkedin.com/company/intelligent-computing-solutions> > <https://twitter.com/ICSIL> > >
