Allow only pppoe Block the rest!
2014-11-19 0:36 GMT+01:00 George Skorup (Cyber Broadcasting) via Af <[email protected]>: > We do only bridge mode and DHCP to the customer's equipment. But I do check > the PPPoE filter because it lets me easily see when a customer's router is > configured for PPPoE (Stats > Filter). I also use the filters for BootP > server, SNMP, SMB and multicast. This is some of the best stuff about > Canopy. So I would prefer the ePMP to work like Canopy, for the most part > anyway. > > > On 11/18/2014 3:13 PM, Matt via Af wrote: >>> >>> I am Dan Sullivan and I am the software manager for ePMP at Cambium. >>> >>> Why do you want to filter PPPoE? Can you explain the use case more for >>> me. >>> >>> When our SM is set up as a PPPoE client and is talking to a PPPoE server, >>> it will only accept traffic from the PPPoE server over the wireless >>> interface. With this in mind, why do you need a PPPoE filter for the >>> wireless interface? >>> >>> One other item, when NAT mode is enabled we can set up a L2 filter for a >>> source MAC and EtherType as indicated below, but only the source MAC filter >>> will work. There is a warning message that indicates this when in NAT mode. >> >> I think the desired affect is the same as: >> >> On Canopy 450 SM >> "Config / Protocol Filtering" >> "Packet Filter Configuration" >> >> Packet Direction: Filter Direction Upstream Checked >> Packet Filter Types: Check Everything BUT "PPPoE" >> >> This way the customer router/PC they plug into the ethernet port on >> the SM can only successfully send PPPoE traffic onto our network. > >
