Yah, my AP is not showing up there at all. But the refresh seems dreadfully
slow on these. I have it set to 2 seconds. I only have the upper band from
5740-58xx checked.
Are you successfully getting any kind of range with the 110s?
On Tuesday, December 23, 2014 3:54 PM, Josh Luthman via Af <[email protected]>
wrote:
Go to monitor wireless. That's all the APs it can see with the
frequencies/sizes you've enabled.I would suggest limiting the frequencies to
the band you're deployed in. Saves time in scanning.Josh Luthman
Office: 937-552-2340
Direct: 937-552-2343
1100 Wayne St
Suite 1337
Troy, OH 45373On Dec 23, 2014 4:49 PM, "Alan West via Af" <[email protected]> wrote:
Hello all.
I am playing with a EPMP system to try to offload some customers over to it
from my legacy 100 series network. I have a single 120 sector running 5.7 at
about 180ft. Software is 2.3.3. Running on 20mhz channel.
I have four EPMP Force 110s I am evaluating. I have one of them working at a
customers home at 5.7 miles. Not perfect, but working.
I cannot get a signal at all at another home very close to the other, at 5.9
miles. This is going over open farmland, however, it is not line of site
(neither is the one above). There are a couple of small tree lines in the path.
They are not very wide at all, perhaps only one or two trees deep. Each is
along a creek.
Is anyone else having issues with these? Maybe I have something configured
wrong.
