I seem to recall UBNT claiming you could put the ever 6-8 degrees without impact
On Wed, Jan 7, 2015 at 11:47 PM, Jeremy <[email protected]> wrote: > Utah > > On Wed, Jan 7, 2015 at 10:10 PM, Jon Langeler <[email protected]> > wrote: > >> you can easily put 4 links on the same tower every 90deg. All would >> typically have the same Tx on the tower side. 10mi? what state? >> >> Sent from my iPhone >> >> On Jan 7, 2015, at 11:51 PM, Jeremy <[email protected]> wrote: >> >> There is a company here with four on one tower. I have no idea how they >> aren't interfering with themselves. Then again, they are also shooting one >> 9.5 miles and another 4.5 miles and another 8.5 miles. Not this guy! >> >> On Wed, Jan 7, 2015 at 9:48 PM, Josh Reynolds <[email protected]> >> wrote: >> >>> Tripods within 3ft of one another, different to and rx on the site >>> >>> >>> On January 7, 2015 7:46:41 PM AKST, Jon Langeler < >>> [email protected]> wrote: >>>> >>>> so your saying you mixed the Tx/Rx channel between high and low on the >>>> same tower and it works good? >>>> >>>> Sent from my iPhone >>>> >>>> On Jan 7, 2015, at 11:36 PM, Josh Reynolds <[email protected]> wrote: >>>> >>>> The beamwidth is pretty narrow. We have many back to back running FD on >>>> opposite TX and RX, but none on the same azimuth. >>>> >>>> On January 7, 2015 6:54:36 PM AKST, Erich Kaiser < >>>> [email protected]> wrote: >>>>> >>>>> >>>>> Can you stack two AF24s on top of eachother as long as the TX >>>>> frequencies are the opposite and both are master units or do we need to >>>>> run >>>>> in HDX mode? >>>>> >>>>> Erich >>>>> >>>> >>>> -- >>>> Sent from my Android device with K-9 Mail. Please excuse my brevity. >>>> >>>> >>> -- >>> Sent from my Android device with K-9 Mail. Please excuse my brevity. >>> >> >> > -- All parts should go together without forcing. You must remember that the parts you are reassembling were disassembled by you. Therefore, if you can't get them together again, there must be a reason. By all means, do not use a hammer. -- IBM maintenance manual, 1925
