You wouldn't want the dremel sized ones for a padlock anyway....they'd
get too hot and shatter before you finished.
....Maybe the 4" ones for an angle grinder. You can put angle grinder
disks into a drill if you put a bolt through the hole in the middle and
tighten a nut on it. Then you chuck the drill onto the bolt. I've done
that to use the brush or sander disks in a drill. You might be right
about the RPM's with a cutoff wheel.
I don't think a drill has the RPM to make the wheel effective.
-Ty
On Fri, Jan 9, 2015 at 9:16 AM, Josh Luthman
<[email protected] <mailto:[email protected]>> wrote:
Here and there we need to cut bolts and padlocks when people
forget their combos. What would I look for to get a small wheel
that fits in your average drill chuck? I want to avoid a dremel
for cost and another battery reasons
Josh Luthman
Office: 937-552-2340 <tel:937-552-2340>
Direct: 937-552-2343 <tel:937-552-2343>
1100 Wayne St
Suite 1337
Troy, OH 45373
