I had an ePMP AP suddenly stop responding last week. Ethernet link
showed up. Bounced the MT port and it was restored. Didn't have to
power-cycle the radio.
On 3/4/2015 8:31 AM, John Woodfield wrote:
It started responding to pings again out of nowhere but throwing
errors on the switch interface. Going to replace it and the wire
Saturday when this weather clears out. Thankful for redundant back hauls
Sent from my iPhone
On Mar 4, 2015, at 9:29 AM, John Woodfield <[email protected]
<mailto:[email protected]>> wrote:
Heading out this afternoon to move to a switchable Poe port.
Sent from my iPhone
On Mar 4, 2015, at 8:18 AM, [email protected]
<mailto:[email protected]> <[email protected]
<mailto:[email protected]>> wrote:
Have you tried power cycling it? We haven't seen a single ePMP failure.
On Wed, Mar 4, 2015 at 7:47 AM, John Woodfield
<[email protected] <mailto:[email protected]>> wrote:
Funny thing is I can ping it from the SM side but I can't SSH
into it.
John Woodfield, President
Delmarva WiFi Inc.
410-870-WiFi
-----Original Message-----
From: "John Woodfield" <[email protected]
<mailto:[email protected]>>
Sent: Wednesday, March 4, 2015 7:38am
To: [email protected] <mailto:[email protected]>
Subject: [AFMUG] ePMP Failure
Had an ePMP sector we put up a couple months ago. Has been
sitting, transmitting with no associations no problem. Put it
temporarily in PTP mode last night and cranked the power to 30.
It lasted about 12 hours and now I show no link to the switch port.
Anybody else have problems killing these with the power cranked
up or other reason or is this just a fluke?
John Woodfield, President
Delmarva WiFi Inc.
410-870-WiFi
